Question Locked

Recovering data in a badly damaged XP environment

0 helpful
6 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have this HDD that has pictures in it and anytime I tried to recover the pics, It just don't let me do it. I mounted it in an external case to read it as an USB mass sotrage device and got no results. I ran GetDataback for NTFS and after I got it scanned i cannot preview any of the pics I save in my main HDD. Is there any other software that can give me better results?

6 replies

by oh smeg

The Drive [b]Is Not[/b] correctly fitted tot he Enclosure.

Now depending on what type of HDD this is things vary a bit but assuming that it is a IDE Drive of some sort there need to be set to Master Not [b]CS or Cable Select[/b] when fitted to a External Case. Try removing the drive from the case and setting the Jumper on it to Master.

Also depending on what security you had on the XP install you may need to [b]Take Ownership of the Files/Folder/s[/b] by following the directions here.

http://support.microsoft.com/default.aspx?scid=kb;en-us;308421

Col

by djfrankn

c Thanks for your response. It's my mistake that I forgot to mention it is a SATA hard drive. Now I tried PC Inspector Smart Recovery and (through deep scan) I was ablle to recover a handful of pictures. Would you please let me know if there's something I can do?. Meanwhile, let me say that the files are not security protected. Thanks for any help, Frank

by oh smeg

Is the Interface Card between the USB Lead and the HDD.

When you get this type of Error Message it generally means that either it's an IDE Drive not jumpered Correctly or there isn't enough Power to the Drive.

If this has it's own Power Supply you'll need to check the Power Supply for the correct Voltage and Current. If this is a 2.5 Inch HDD type you'll need to plug both of the USB Plugs on the Y Cable into different USB Sockets on the M'Board or into a Powered USB Hub.

The USB plug at the end of the Y Cable is a Power Only Plug while the one in the middle is a Power & Data Plug. The USB Standard supposed that there is 500 Milliamperes at each USB Socket and drives bigger than 80 GIG need more than the 500 Milliamperes available so you need to make sure that the USB Plugs are in different USB Sockets and not connected to a Unpowered Hub that is getting all of the power from just the 1 USB Socket.

Sorry but that's all I can think of here. ;)

Col

by jacobluis

Hello friend your data have been lost u can recovery it to use the data recovery product of stellar ..

This discussion is closed to new replies.