Question Locked

Recovering information from a Laptop Hard Drive?

0 helpful
13 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have a very, very expensive paper weight that killed me when it died a handful of years back. I've always wanted to recover the information from the hard drive.

The only problem is, it was a gaming laptop and the hard drive setup was a RAID-0, which I'm sure was a hardware RAID. I don't have another laptop that supports this on-hand.

Is there a way that I can recover this info? Is there an external enclosure that I might be able to get that will do this? I wouldn't mind keeping the hard drive around for further use after I recover the information.

If I put each hard drive into separate enclosures, will that work if I set them up as a RAID 0?

13 replies

by oldbaritone

I bought a USB cable that will plug into a laptop drive. It wasn't expensive, around 50 bucks with a PS for the drive.

Is it worth risking that much to find out? I was lucky and it worked. You might be lucky too, and the worst would be 50 bucks spent that didn't help.

by tehchodja

I saw one of those for 20 bucks. I figured it would be worth a shot, and I'll totally look into that when I get the money.

Getting two of them and then raiding them together through the Disk Manager should work, right? I heard something about requiring the same Raid Controller or something for it to work...

by cg it

and the laptop SATA controller supported RAID 0 striped.

you want to get data off the drives? do you have both drives? if not your screwed. Data in a striped RAID array is spanned across both drives so you need both drives to get usable data from it.

by tehchodja

It's two IDE hard drives, actually.
And yes, I have both drives. I believe they are both functional as well.

by dawgit

If there is only One physical Hard Drive (Two in a Laptop is a bit rare) then you had Software RAID, not Hardware RAID. Hardware RAID would need at least TWO separate Hard Drives.
RAID 0 is the easiest to recover from, especially if it's all on one drive.
If that's the case than another Software RAID software program might just do the trick.
Good Luck.

by cg it

and if one of the drives is external, how that would work, lose the external drive, bam the RAID array won't work or boot.

by dawgit

Feel better?
That nice, warm fuzzy feeling that nice sales rep tried to give them?

by tehchodja

It's two separate drives connected to one IDE controller. I'm assuming primary and then secondary, and I'm also assuming it was a hardware RAID. It still continued to act as a whole hard drive when I completely dumped XP on separate occasions and rebooted XP freshly.

It's an Alienware laptop, if that helps any.

by cg it

you could stick em in a desktop and possibly pull data off,

might simply try only 1 and see if there's data you can pull off with only 1 drive...

by dawgit

If both are connected to the same IDE connection. then it's not likely to be a Hardware RAID, but a Software RAID. 'Normally' a Hardware RAID set-up will use separate connectors. (2 IDE plugs, 1 for each)
If the drives are connected together you should be able to connect them that way in another computer.

by tehchodja

I think that's exactly what I'm going to try and do... I have some spare parts lying around that I can throw together to make a project PC. Although, looking through my drivers the other day on my Desktop computer, it has AMD Raid software/drivers, so I may just use that.

I'm crossing my fingers, and I'll get back to you on what happens.

This discussion is closed to new replies.