Windows Forum

Ask something
Discussion Locked

Redundant NIC

0 helpful
5 replies

by bfairchild

Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I would like to put two NICs in my win2k server so that if the primary connection fails the second will take over. There are actually 2 servers in a Microsoft Cluster(HPlt6000r servers). Each card would connect to a different switch in the same IPsubnet. Where can I find info on how to set this up?

Thanks,

Bill

5 replies

by syke

Hello. I'm not sure if this is exactly what you are looking for, but here goes. The best fault tolerant NIC setup I have seen in operation was 2 Intel Pro S cards. I believe info came with them how to set them up in tandem for load sharing and fault tolerance, and there is also documentation on the Intel site (or used to be, haven't checked in about 8 months).

Just a thought..

Syke

by bfairchild

Haven't had a chance to look at these links, but I did find out the answer to my question about redundant nic's and different subnets.

This discussion is closed to new replies.