Discussion Locked

Reformat and reinstall of NT4 and Exchan

0 helpful
10 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I need to reformat and reinstall NT4 and Exchange. I have a system with four hard drives each divided into partitions (which I did through NT's Disk Manager Utility). If I reformat only my O/S drive (which has a partition for NT O/S and a partition for Exchange), will my other drives partitions and labels still be recognized or am I going to have to start from scratch on all of them? I'm reformatting to change the server from a PDC to a BDC. Thank you.

10 replies

by timwalsh

Couple of things:

You don't need to reinstall the OS to change from a PDC to a BDC unless the BDC will exist in a different domain.

Answer 1 is correct about your other partitions still being recognized. However, be aware that if these partitions have any programs installed on them, they will still need to be reinstalled if you reinstall your OS.

Also, if any of these other partitions contain data files related to your Exchange installation, none of this data will be recognized when you reinstall Exchange.

by systhine from tampabay.rr.com

This is a hack I've used sucessfully quite a few times. It's saved a lot of headaches. I suggest you start experimenting with PDC/BDC/Standalone roles on spare PCs. You can do some facsinating things by hacking the registry (and, more specifically, the security-related keys).

http://www.nthelp.com/40/pdc2bdc1.htm

There's an easy way to access the security related keys in the registry (as only the system has access to it and running regedit as admin or lower will cause these keys to be disabled): Install regedit as a service and run it as system (use the instsrv tool from the NT resource kit). This will cause an error in the service manager, but you can use regedit until you clear the error. This method of running regedit is quite dirty, but it gets the job done in an emergency.

All that is required after that is to reboot your server.

by green lantern

To change a PDC to a BDC just promote any available BDC to PDC and this process will demote the PDC. If the other partitions are just holding data the data will be there after the new installation marks the drives for NT access, a process you won'tnormally even be aware of. If you have installed programs on those partitions, you will have to reinstall those programs. If exchnange data is currently on those partitions then the new Exchange server will not recognize that data and it will be lost. I recall there is a way to import data from one exchange system to another but do not remember the specifics.

This discussion is closed to new replies.