Discussion Locked
0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have WIN 2000 server and am trying to setup dial up remote access, everything seems to work fine, the modem answers, verifies username and password, but then I get "the computer you dialed disconnected". I can use terminal services in the LAN withthe DHCP server we currently have. I have gone through the remote access settings and cannot figure out what I may be missing (IP assignment maybe?), I am trying to access dial up with Dial Up Networking on a WIN 98 pc. any help would be nice!!
3 replies
open routing and remote access mmc
1. in server propeties ip tab configure ip
assignment
2. in remote accsses policy open default policy and change the default setings that
deny dail in .
3.the easyest way to check if everything is
o.k ,is tocreate a loopback vpn on the server. so create a vpn connection on the server configure it not to dial the initial
connection .if you are able to connect than no reason why a connection from another machin wont wark
by terro
Poster rated this answer
by terro
This question was closed by the author
This discussion is closed to new replies.
Trending Windows Forum posts
Sort by Trending
1 helpful
20 replies
0 helpful
6 replies
0 helpful
12 replies
1 helpful
9 replies
Discussion
Do you think that business directories are relevant to Local SEO And Lead Generation today
0 helpful
14 replies