Question Locked

replaced inspiron 4000 motherboard, and there are issues

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
the new board is for the inspiron 4000 and latitiude c600. it boots as a c600. how do i correct this? the other issue is that it will boot from battery, but with power cord it cuts off after 2 or 3 seconds. it also just decides to cut out at different points while running. actually i am not sure if there is an issue whether it is a 4000, or c600 as long as it runs the same. it reads the cpu ok so i don't know if it matters.

4 replies

by hezkiah

did you up grade the bios when you installed your mother board

by ---tk---

or who ever replaced the MB... and have them replace it with the correct one. Its not uncommon to order a MB from HP and its DOA or the wrong part...

by ken

I have a HP Compaq that would do this. I resoldered the power connector on the mother board and that fixed it.

This discussion is closed to new replies.