4 replies
by fullseptic Accepted solution
by jamesatmaisonverre Accepted solution
Because it is a raid system (presumably raid 5)i would suggest you follw two routes.
1.the raid system is designed so that if one hard drive fails then no data is lost.So if you replace the drives one by one it will copy all the info to your new drives one by one.
2.backup everything on your present hdd and do a restore to the new hdd
by jamison.hooper Accepted solution
I'd go for option 2 for these two reasons.
1. You don't want to mess with your RAID, without a backup.
2. If you pull a 160g drive and rebuilt the array using a 500g drive, you're going to use 160g of the 500g available.
by timthew Accepted solution
1) remove 1 drive at a time, and let array rebuild
2) Once array is completely rebuilt with new disks striped across the original 160Gb of the array, convert the volume to a dynamic volume using MS Disk Manager.
3) create and format a new volume on the remainder of the new higher capacity array.
4) Span existing partition across newly created parition on the dynamic disk, creating a single, expanded partition totalling the 500Gb.
We have used this method for three of our primary file servers when faced with expanding capacity. In fact, I am set to perform this exact procedure during a maintenance window tonight..
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending