Discussion Locked

RIS Image Download Problem

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hello -- I am havivg a problem with RIS on my network.

I connect to the RIS/DHCP server (with a new client) via a PXE NIC, I receive an IP address via DHCP and the "Client Installation Wizard" appears.

After successfully authenticating, the installation appears to start (loads the device drivers / Executive).

It is at this point, at the "Setup is starting Windows 2000 screen" that new client monitor goes black and
everything stops and just hangs.

Has anyone else experienced these types of aborted image downloads?? Can anyone please help??

5 replies

by here's one for you

This might not be the answer that you are looking for, but to at least start you troubleshooting you must ensure that all your hardware is on the HCL as supplied by Microsoft. You could also try and loadf your stanard BIOs defaults in order for W2K to correctly enumarate(read) your hardware.

by jon pratt

It sounds like the system you're trying to load the image on has a "required" device that w2k can't drive with its standard driver cabinet. The two main devices that RIS must be able to talk to are the video card (almost never the problem due to generic VGA capabilities) and the hard drive (almost always the problem). I'm betting that there's a problem with the HAL being able to talk to your hard drive. If you're using SCSI/RAID, especially off board, that?s most likely the source of the problem. When w2k starts loading hit F6 and load the device driver that the SCSI/RAID adapter came with. If the machine you're using has an IDE HD w2k can usually drive it with a generic ATAPI IDE driver, however, I have seen a few exceptions with either very strange chipsets (e.g. when the VIA chipset first came out) or IDE controller cards (e.g. ATA66/100 controllers). If you are using an off board IDE controller then you need to follow the same procedure you would with a SCSI/RAID adapter (i.e. hit F6 and load the OEM driver). Sometimes the NIC requires a PXE boot agent BIOS flash because it's Rev. is too old to function properly with RIS, however, I've only seen this result in the RIS installation not initializing at all rather than starting and failing. Personally, I would focus on the hardware. It is unlikely that this is a problem with RIS, since you can progress through the RIS setup screens and into the w2k setup. If you want to eliminate RIS as the culprit altogether thenthrow a w2k pro bootable CD into the target machine and try loading w2k from that. Once you have chosen what image you wish to load from the RIS menu and it starts the w2k install, as you've done, then there's really no difference between loading the OS from a CD and RIS (which is why I suspect hardware). Hope this helps. Good Luck!

This discussion is closed to new replies.