Discussion Locked

Routing and remote access

0 helpful
8 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I am getting an error message....Unable to start Routing and Remote Access service.
How can i fix this problem. It seems as though it was never installed could this be the problem?

8 replies

by stillatit

It does not install by default. Look in the services list, and see what happens if you try to manually start it. Then take a look at the event viewer and see if there is any other information there.

If the problem is not obvious, post a comment with the information from the event viewer entries that occured when it tried to start.

Good luck.

by chinookclub

OK I went to services and tried to start in up manually and it got an error message
"Could not start....the service did not return an error. This could be an internal windows error"
SHould I reinstall? Any other ways of fixing?
Thanks

by magetower

I would suggest removing and re-installing the service and make sure to re-apply the service pack level you are using on the system.

by ian mclaws

RRAS must be configured before starting the service. It is loaded, but you must first open the Routing and Remote Access MMC from the admin tools. Right click your server and choose "configure the server". After configuration, the service will startitself, and should start from boot thereafter.

Good luck,

Ian

This discussion is closed to new replies.