SATA and IDE HDs together
Question
can I add a SATA HD(250G) to an IDE HD(160G) and get one drive with a total space of 410G?
If so how?
Hardware
Question
can I add a SATA HD(250G) to an IDE HD(160G) and get one drive with a total space of 410G?
If so how?
by mlathangue Accepted solution
by techexec2 Accepted solution
Assuming you are running Windows XP...
Yes. You can accomplish what you want by converting both disks to "Dynamic Disks" and creating a "spanned" volume. Be sure to note the caveats in this Knowledge Base article (1) !!
(1) How To Convert to Basic and Dynamic Disks in Windows XP Professional
http://support.microsoft.com/kb/309044
by gjohnson Accepted solution
by techexec2 Accepted solution
I did not comment on the pros and cons of spanning. I just explained how.
The additional risk of spanning is:
When you use spanning, you INCREASE the likelihood that you will lose data due to a drive failure. Now, when EITHER drive fails, the data on BOTH drives will be lost. You can offset this increased risk by using RAID instead of spanning. But, you'll have to use more than just 2 physical drives to do it.
The advice is still the same, however. Make regular backups and you will not lose your data.
by microb Accepted solution
by hal 9000 Accepted solution
There is one more step that you are going to have to take when you fit the SATA Drive and that will be to install the SATA Drivers so that the drive can be accessed.
Depending on the make of the system sometimes this isn't necessary and other times the drive will just fail to be seen until the correct drivers are installed for the SATA Controller.
When you got your system there should have been a M'Board Floppy with the SATA Drivers on it and they will also be on the M'Board CD. However if you brought an off the shelf system you'll most likely have to visit the makers web site with your Make & Model and the Serial Number to get the correct SATA Drivers for your system.
Once you have these installed you can then set about creating your Spanned drive.
Col
by mlathangue Accepted solution
by techexec2 Accepted solution
Before you proceed, you should make a backup of all of your data.
If the conversion to dynamic disk completes normally, you will not lose any data. But, if anything goes wrong, you could lose everything. This includes a software bug, hardware glitch, or power failure.
You should be making backups regularly. Whenever you do something like this, you should always have a current backup available.
by mlathangue Accepted solution
This discussion is closed to new replies.
Sort by Trending