Question Locked

SATA HDD wont boot

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I installed a WD 250G SATA with 2 WD 80G HDD's that were my C and F drive. I made a mirror image of my C using ACRONUS, and put it on my SATA because as i understand it the sata has to be MASTER. However, once i did that the SATA would not boot, and the original C would not boot. My asus p5vd2-mx se does recognize all the drives, and the motherboard is new.I did A clean install of WINXP. I have downloaded the drivers for the motherboard and without the 2nd IDE HDD in, the SATA booted. Once i hooked up the 2nd IDE HDD it has not booted since and that was last night. Enyone?????

2 replies

by hal 9000

What happens is that some files get written to the first IDE Drive and point the Boot Loader to the second drive which in this case was a SATA Drive. When you installed another IDE Drive that became the second HDD to the computer and the Boot Loader is being pointed to that instead of the SATA Drive. You can fix this fairly easily provided that you haven't applied all of the available updates by doing a In Place Install of XP by following the directions here

http://preview.tinyurl.com/g4bv8

Of if you remove the second IDE Drive the system should boot again. If you do an In Place Install you'll have to reapply all of the Patches that have been released since your copy of XP was made.

Col

This discussion is closed to new replies.