Question Locked

SATA to IDE Adapter

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Hi, I recently bought an SATA/IDE adapter because my motherboard is a SATA board and I have two optical drives. I have tried multiple jumper settings but I cannot get bios to recognize the SATA drive. Thanks.

3 replies

by hal 9000

Generally speaking depending on the chip set of the M'Board it only looks at the 1 IDE Lead on the M'Board and if there are optical drives mounted there they will be invisible to the BIOS as an Optical Drive has no Physical Characteristics let alone any drivers loaded at that stage to be able to read whatever may be in the Optical Drive.

What you need to do is set the Boot Sequence to Floppy if there is one then Optical Drive and finally HDD and maybe if there is another option LAN if that is available and necessary. Generally speaking you can leave the last 2 options unassigned so you only have Optical Drive and then HDD to boot from.

When it comes to SATA drives you need to load the SATA Driver that comes with the M'Board by pressing the [b]F6[/b] key at the beginning of the Windows Setup when prompted to apply any SCSI or other Drivers and then run these from the root of a Floppy so that they can be loaded.

You'll need to keep the Optical Drives on the IDE Chanel so that you can boot from the Master and load your Preferred OS.

Some NVidia M'Boards do not require SATA Drivers but most others do so depending on the M'Board in use you need to use the drivers supplied with it or if it is a NVidia Board allow Windows or whatever your preferred OS is to Install and auto Load the default drivers for the M'Board.

But you will always have a Floppy Connector and 1 IDE Connector on the M'Board as you need these to boot from and be able to fit the Drives. Sometimes the Floppy is forgotten but never an Optical Drive which should always be mounted on the end of the IDE Lead. If you can not boot from this drive check the IDE Lead for the correct orientation at the M'Board and the Drive as if it is in the wrong way at one end it will not work. If you have a M'Board that needs SATA Divers Loaded you'll need either a Floppy Drive or USB Stick with the Drives copied to the Root of the Floppy or USB Thumb Drive though the Floppy would be the better of the two most times.

Col

by druuzil

I just installed one of these adapters today on an older IDE Seagate HD. My first attempt at booting the machine didn't get past post. I then read the manual that came with the unit (poorly written, but in this case it was useful enough) and it said that you need to set your device as "Master" even if you have another device with that desingation already. If you've already tried this... *shrug*

*edit* Did you plug in a Molex connector to the HD itself? The 4 pin FDD connector only gives power to the adapter, not the HD itself.

This discussion is closed to new replies.