This should be an easy fix. Normally but the only thing that I can think of is that when the original IDE Drive failed it took away that MBR on the SATA Drive and that is what the problem is now.
When you look at the Drive in Computer Management does it show up as Formatted or Unallocated?
The only thing that I can think of here is that when you installed the OS you accidentally installed it to your Data Drive and you have a blank drive that you where going to use as your OS Drive or that when the IDE Drive failed it damaged the Partition on the SATA Drive.
[i]Should i be saving this driver to a floppy and applying it during a windows reload?[/i]
As for the SATA Driver you need to save it to the Root of a Floppy so you can install it during the Windows Install or you'll be unable to install it and have it work correctly.
[i]Before my last IDE HDD died I had to re-instll windows which went fine. I applied the RAID driver after the install was complete and was able to see the HDD which was automatically assigned a drive letter. The last config was the same as I have now with an IDE for the OS and trying to see the SATA HDD using the SATA/RAID Driver.[/i]
This is exactly what should happen if the SATA drive is intact but it's possible that the Partition Information has been damaged when the original IDE drive failed for some reason this really depends on what was happening at the time you may need to do some Data Recovery Work on the drive to reconstruct the Contents of it if that's the case. If you have access to On Tracks Easy Data Recovery that will allow you to rebuild the MBR/Partition Information or whatever you like to call it easily but if you don't have a copy it's not cheap and not something that I would consider buying unless you have a need for it though it is very good.
[i]With a standard IDE drive when you reinstall windows the data on the drive remains intact - is this the same with a SATA or am I barking up the wrong tree??[/i]
This is what should happen though if you suffer a drive failure anythings possible.
[i]FYI - Apart from the two SATA connectors on the Mobo I also have a SAT PCI card which I could use if this will help? My new SATA is a Samsung which also has accompanying drivers.[/i]
You can try this but I don't think that you'll see any difference as for the drivers that come with the Samsung HDD these are most likely for a M'Board that can not recognise a drive that big and trick the BIOS into seeing the drive differently but if the drive can be fully seen and formats up to close to it's stated size these shouldn't be required.
Col