Discussion Locked

Scandisc always runs at startup

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I routinely close windows in the proper manner i.e. from the start menu. When the system says it's OK to remove power, I do so.
When I Reapply power, I get a message saying windows was not shut down properly and scandisc runs again. Any suggestions?

7 replies

by dmiles

1)Click Start,in Run box type in MSCONFIG,and uncheck the box to run scandisk at startup
2)The problem can occur when the IDE Harddrive Cache needs to be updated,go to Windows Update,select the products update,locate the Windows IDE Hard drive Cache Package and download the update.

by skutts

edit MSDOS.SYS, and under
[Options] either ammend or insert a line thus:

AutoScan=0

this will prevent the system from running scandisk on any boot. the disadvantage being that if you dont shut down correctly, you will have to remember to run scandisk from within windows, just in case there is a problem

This discussion is closed to new replies.