Discussion Locked

Scandisk won't run on Bootup (W95)

0 helpful
6 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hello Folks

Every time I reboot my computer I get a message during startup saying that one or more of my hard drives may have developed bad sectors and that I should press any key to run Scandisk to attempt to correct the problem. So, I press enter. Then a second message is displayed telling me that there was an error starting Scandisk and that I should start it manually, and that I should press any key to continue loading Windows.

Now, I have used DiskDoctor from Norton Utilities 2000 toscan all my hard drives using the 'thorough' option for the surface test. No problems were detected. However, my computer is still displaying the message, followed by the unable to start Scandisk message.

What is going on? How can I get round this? It is not a major hassle pressing enter twice during startup but it disturbs my karma. Can I edit scandisk's ini file? Is there a modification I can make to one of the bootup files such as MSDOS.sys or IO.sys?

This 'affliction' is also present on one other computer on my network. Any help from you guys would be appreciated.

Thanking you in advance...

Mark

6 replies

by lo

Just guessing on this. Is this possibly a virus? Also, might just go into the disk property and request a ScanDisk, then reboot. If you have a 2nd partition, check that you can run ScanDisk on it. Might also try booting to dos and run scandisk on your C: partition.

If you have any means of doing backup, do that before you do andy scandisk. You are playing in a bit of a grey area and can corrupt the system.

by blackcurrant

Thanks for the tips. I have not as yet run Scandisk on any of my drives. The amount of time taken by Scandisk runs into hours! I have checked all of them with Norton DiskDoctor (overnight).

Both computers have also been virus checked but nonewas found. I am sure this is a glitch, and I have a gut feeling that this problem can be resolved by editing an ini file or, more likely, as suggested by Phosler, by editing the registry.

I do not have scandisk set to run in startup, autoexec.bat, win.ini nor the run section in the registry.

This discussion is closed to new replies.