Question Locked

SCSI access through IDE

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hi,
I have a SCSI disk that I am trying to access through my WIND XP, which is in an IDE disk.

I am using Adaptec 29160 SCSI controller, and windows sees it and installs the drivers just fine.
When I connect the SCSI disk to the controller and try to boot from my IDE disk (XP), XP never starts. It just keeps rebooting.

Anybody has any idea what else I need to do?

5 replies

by jmgarvin

Try to boot to safe mode....Also, make sure the boot order in your BIOS is correct.

by oh smeg

If the hardware is correctly installed it sounds as if the computer is trying to boot from the SCSI drive.

Also look at the address number of the SCSI Drive it should be anything but 1 or 0 depending on what the Controller is set to by default.

Do you know what is on the SCSI Drive? If it's a copy of any OS I would think that the unit is looking at the SCSI and attempting to load from there. Depending on the make & model of your M'Board you may not be able to do anything about this either as SCSI on some M'Boards is the default Drive when installed.

Col

by mane

Hi Col, yes there is an OS in the SCSI disk.
The address is 6 (so this should be fine).

Do you think booting in safe mode might help?
Thank you

by oh smeg

Though you may still be booting off the SCSI Drive. But if you can get Windows to load even in Safe Mode off the SCSI you will be further ahead that you currently are.

If you find that the SCSI OS's is the one loading and you want the IDE's OS to load you only have the option of altering the BIOS and if that doesn't work you may be between a Rock & a Hard Place.

Col

This discussion is closed to new replies.