Discussion Locked

Serial Mouse no working.

0 helpful
11 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Windows 98SE will not recognize a serial mouse. How do I get it to recognize the serial mouse?

11 replies

by dmiles

Use the Keyboard to Open the Control Panel,navigate to System icon and hit enter,navigate to the Mouse and hit enter,when the box opens you can navigate by using the tab key and hit enter,load the driver by using tab to the button to highlight,load drivers and click Okay and Reboot.
Alt+Esc-to open the Start Menu
Tab to navigate to the icons and buttons
Enter to select

by dmiles

Use the Keyboard to Open the Control Panel,navigate to System icon and hit enter,navigate to the Mouse and hit enter,when the box opens you can navigate by using the tab key and hit enter,load the driver by using tab to the button to highlight,load drivers and click Okay and Reboot.
Cntrl+Esc-to open the Start Menu
Tab to navigate to the icons and buttons
Enter to select

by jctech

If you haven't already done so, you might want to check your serial ports in device manager for any IRQ conflicts or other problems. Go to Start|Settings|Control Panel and press tab and up/down and left/right arrow keys to select System, then pressEnter to open the properties. Then select the device manager tab and look under Ports for a yellow circle with an exclamation mark in it. If none show up, try rebooting and enter safe mode. Then open device manager again to see if there are multiple instances of the serial ports. If there are, remove all instances and reboot. Windows should redetect the ports and hopefully, all will be well.

by gumbytech

1) Remove the following registry key:
HKEY_LOCAL_MACHINE\System\CurrentControlSet\Services\Class\Mouse\
where is an incremental four-digit number starting at 0000.

2) Remove the following registry keys, if they exist:
HKEY_LOCAL_MACHINE\Enum\Root\Mouse\
where in an incremental four-digit number starting at 0000.

3) Remove all registry keys under the following registry key, if they exist:
HKEY_LOCAL_MACHINE\Enum\Serenum

4) Remove the following registry key, if it exists:
HKEY_LOCAL_MACHINE\Software\Logitech\Mouseware

5) Right-click My Computer, and then click Properties.

On the Device Manager tab, click each serial pointing device, and then click Remove.

Click OK.

Restart Windows.

When you restart Windows, the attached pointing device is detected and the appropriate drivers are installed.

by jesselou

inspect your peripheral connections under the bios and examine your ports enter the default values supplied by your computer manufacturer usually a pc compatible would show port1= 3f8h and port2=2f8h.when you are done inspect the cord of your mouse and make sure it is properly plug, restart your computer.

This discussion is closed to new replies.