Discussion Locked

Service Control Manager Error

0 helpful
10 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hi,
I have a system on the bench running NT 4.0 with a pII 200MHZ, AT Keyboard. Every time the system boots I receive this message. "At least one service or driver failed during system startup. Use event viewer to examine the event log for details". In event viewer I have the letter i in a blue circle,date,time and under source I have save dumo, event log, event log, serial. Category none and event 1000, 6005, 6009. I do not know how to interpret this viewer.
Please tell me whats going on if you can.
Thank You

10 replies

by tamj123

Letter I in a blue circle, is for information only,not a error you want to look letter X with red circle(significant problem), and ! with trangle (An event that is not necessarily significant, but may indicate a possible future problem), make sure you check all three system, application and security log.
Go to microsoft website and type in the event ID number, it will tell what wrong and how to fix the problem (in most of the case).

hope this will help.

by casemaker

Hi,
Thanks for the answer. I went to event viewer and in Applications there are all blue circles with I's from 1/25/98 to 8/23/01. In Security there is nothing. in system from 1/20/00 to 8/23/01 there are blue circles with i's.
There does not appear to be errors

by ceo_race

Check your event log again by double clicking on on of the errors and you can read the entries. Probably the dhcp,dns, or some other service did not start and it is not critical enough to be listed as an error.

by ceo_race

Check your event log again by double clicking on on of the errors and you can read the entries. Probably the dhcp,dns, or some other service did not start and it is not critical enough to be listed as an error.

by casemaker

In the event viewer under system I have one log. It says "user configuration data for parameter Com1 overriding firmware configuration data"
Does this help?

by tamj123

if you know which service is cause the problem, the goto control panel and double click on service, highlight the service that cause the problem then click on startup, and select disable. restart the system.

by casemaker

Thanks,
I go into services and there is nothing to disable for com 1 which the error is saying is the problem. When i view the error it says. user configuration data for parameter Com1 overriding firmware configuration data.

This discussion is closed to new replies.