Discussion Locked

Service manager and NtLmSsp not running

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I get a serive or driver failed during start up and this tis the error reported in Event Viewer: The application was started while the service manager was locked and NtLmSsp wasn't running. If the application will try to remote via WinSock Proxy it can cause a deadlock with the service manager. For this reason the remoting is disabled. If the application is a service, and you want it to be able to remote, make it dependent on NtLmSsp.

7 replies

by mdessaint

CAUSE
This behavior can occur when a service that requires the NTLM Security Service Provider (NTMLSSP) service to operate is loaded before NTLMSSP has started. To prevent the Service Control Manager from locking, the service is temporarily unableto make remote calls. The service can be manually started without error after the NTLMSSP has loaded.

RESOLUTION
WARNING: Using Registry Editor incorrectly can cause serious problems that may require you to reinstall your operating system.Microsoft cannot guarantee that problems resulting from the incorrect use of Registry Editor can be solved. Use Registry Editor at your own risk.

For information about how to edit the registry, view the "Changing Keys and Values" Help topic in Registry Editor (Regedit.exe) or the "Add and Delete Information in the Registry" and "Edit Registry Data" Help topics in Regedt32.exe. Note that you should back up the registry before you edit it. If you are running Windows NT or Windows 2000, you should also update your Emergency Repair Disk (ERD).

To resolve this behavior, follow these steps:

Start Registry Editor (Regedt32.exe).

Locate and click the key for the service name indicated in the Event Viewer error messages:

HKEY_LOCAL_MACHINE\System\CurrentControlSet\Services\Fai ledServiceName
NOTE: Match the .exe file listed in the Type field of the Event Viewer message to the ImagePath value of the registry key.

Add the following value:

Value Name: DependOnService
Data Type: REG_MULTI_SZ
Value: NtLmSsp

Click OK to save the values.

When you add this value, the service waits until the NTLMSSP service starts. If the NTLMSSP service has not started, this configuration starts the NTLMSSP service before it starts the other services.

by james_randy

That was a very thoughtful and thorough first answer. Why don't you go ahead and accept that answer and close the question.

by james_randy

That was a very thoughtful and thorough first answer. Why don't you go ahead and accept that answer and close the question.

This discussion is closed to new replies.