Windows Forum

Ask something
Discussion Locked

Service pack 6A installation

0 helpful
3 replies

by murtaza_nasser

Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I am installing SP6A from server to local WS via CMDLINES.TXT file, when I get close to the end of the install, I get error "cannot find class files" Can anybody help.

3 replies

by ddonovan

You might check to see if SP5 is installed at the WS. My first experience with 6a was somewhat less than desireable, and I found out I had to have SP5 installed prior to. If you are not sure about any changes to the system, it may be a good idea to reinstall SP5. Make sure it is the same security level as 6a. I'm just now getting to the stage where some of the software updates actually like it!
Be careful with it and legacy software.
Good luck!

by ann777

I recommend that you copy the install over to the workstation. Any kind of network interruption could cause this loss of memory as to where the class files are located.

This discussion is closed to new replies.