Discussion Locked

Set drive letter for partitioned drive

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have Win ME, not that I think it matters form Win 98. I have a 40gb HD on the primary master, in two 20gb partitions. Fine...there had the C: and D: letters. Then I added a 6gb HD on the primary slave, but it took over the D: drive letter, making my 40gb letters C: and E:....how can I set these, since dvc mgr doesn't allow this type of manipulation for hard drives?

5 replies

by bdgray

Has this new drive been used before? Boot to a Dos prompt and go into FDISK. Delete the partition and recreate it on the new drive(6GB) on the secondary channel.

The only time I have seen this before is when a Drive manager is being used on a drive.

by bigd3000

Thanks, but the drive was in use, and formatted, and the secondary channel was full.

by ielliott

This is a common issue with HD installation. I don't think I have a fix for it (I still have problems with it) but anytime you add a physical HD when there is one with 2 or more partitions already, the physical drive gets placed in front of any extended partitions. You could try a disk manager like partition magic.

by bigd3000

Thanks...I traded the 6g to my friend my some nice Eclipse door speakers in my car. But I know poartition magic would have fixed it.

This discussion is closed to new replies.