setting up a backup domain controller
hi;
just want to ask for assistance on how to setup a backup domain controller.thank you very much.
Windows Forum
hi;
just want to ask for assistance on how to setup a backup domain controller.thank you very much.
by mrehere
What you do is build a second NT server and during the install process you will be asked to make it a 1. PDC 2. BDC or 3. Member server. Make it a BDC. Then later in the install it will ask for the domain to make that server a BDC to. Specify the domain name and also provide an account ID and password that has admin rights. Make sure that the new BDC is physically connected to the LAN that the PDC is before you begin the install as it MUST find the PDC. If it can not, the install will go no further.
MrE
by r_poblete
by dlw6
I concur with MrEHere, but I have a few points of clarification:
1. The new server you're installing as a BDC should be on the same LAN segment (same hub or switch). That will ensure they connect okay. Later you can move it and use LMHOSTS or WINS to point to the PDC.
2. The steps in order are: connect the new machine to the LAN, install NT Server, specify BDC, give the domain information (and a Domain Admin account), finish the install.
3. You can verify a good install in two ways. First, checking Server Manager and seeing if the new machine shows up as a BDC. Then, after you've forced a domain synchronization (done through Server Manager), you can unplug the PDC LAN cable and have someone try to log into a client. If they log in, your BDC is working.
Don
by r_poblete
by r_poblete
This discussion is closed to new replies.
Sort by Trending