Discussion Locked

Setting Up a VPN with NT 4 and a netpia

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Here is my situation. I am connected to the internet via 384K DSL through a netopia router. I have an NT 4 stand alone server with PPTP and VPN ports set up on it. I am using RRAS although I am not very familiar with routing. The way I see it, I have two options, I can configure either my router or the stand alone server to accept the VPN connections. When I had the server set up to accept them, I kept getting an error saying that my username and/or password is in valid on the domain. I now have the router set up to accept VPN connections. When I try to log on, after verifying the username and password, I get errors connecting to the mapped network drives. After this, I cannot see anything in network neighborhood.
I am trying to connect through Win98 with a 56K modem. Do I need to assign a static IP to the client? If so, where? In the protocol itself or in the DUN client? I have never done anything like this before, so the more specific the info, the better. Thank you.

Steve

9 replies

by calves

Steve,
I recall a similar situation while back, it might been you.
The server that receives the PPTP request must to be part of the domain, for it's going to fetch the ip address, authentication, etc for the caller. Your router, should be setup toforward the request on the VPN port to the VPN server (same above), or make sure that the RAS setup allows for the caller to view the "whole network" and not "this computer only". Also, make sure that both server and router (I am not familiar with the config of your router) knows where DHCP, WINS, Gateway are.
Check out a site that I keep www.softsolutionsconsult.com - network
There is good info about VPN, RRAS, NT...

Good Luck!

by Former member

You mnust check the status of the VPN connection between the router and the server. On the router, there should be a way to view the status of the VPN, and On the server, check the event viewer.

Verify the status of the VPN first. THen verify IP addressing.

by mitchsklar

Steve,

This probably won't solve your problem but check these items:

Is the netopia running firmware 7.4.2? If not get it upgraded. (Good Luck)

The router is capable of VPN services, I had netopia configure mine instead of following their tech note itself.

You will need double ip adresses for each users; For example my local desktop pc uses ip#1 and then I have a second ip# that corresponds to my dial in.

People to contact at Netopia are Will, Kat, and Sara. they really now theirstuff.

by mitchsklar

Steve,

This probably won't solve your problem but check these items:

Is the netopia running firmware 7.4.2? If not get it upgraded. (Good Luck)

The router is capable of VPN services, I had netopia configure mine instead of following their tech note itself.

You will need double ip adresses for each users; For example my local desktop pc uses ip#1 and then I have a second ip# that corresponds to my dial in.

People to contact at Netopia are Will, Kat, and Sara. they really now theirstuff.

This discussion is closed to new replies.