Hi you said that you need to set up primary DVD+RW drive and CD ROM drive. I think you need to change your drives jumper settings.
Firstly:
You need to change the jumper settings of both of your drives. The jumper settings will be at the rear side of these drives. The jumpers are just a groups of small plastic caps which inserted to a group of metal pins. The correct jumper settings will be printed on the top side of the drives. You need to make sure to replace these plastic caps to master position in DVD+RW drive and slave position in CD ROM drive.
Secondly:
I want you to locate empty IDE connector on your motherboard. There will be at least one connector. IDE connector are just a groups of metal pins bounded with the plastic rectangle.
Thirdly:
I need you to have one IDE cable which must consist of three sockets. Please connect one socket which located in far side of the cable with the IDE connector on the motherboard. The other two sockets will be use to connect your drives simultaneously.
Fourthly:
I want you to locate two empty drive bays in front of the system casing. Remove two of the fiber caps from bays. Insert drives in these bays. I want you to connect the other two IDE sockets with these two drives. After these you must connect power molex connector from your power supply to supply the require voltage to your drives. And then you are finished.
Let me know whether my information is helpful or not.
Mail to me.
kingaurthor.naylynnaung@gmail.com