7 replies
by parbo
Not sure what the error means but you can try this remove all unnecessary hardware like soundcard, network etc and just leave the basic config with memory, videocard cdrom and harddisk. Then install it again and see if it works. If still not it could be something with the remaining hardware and you have to troubleshoot further like swapping hardware. If it installs fine then you install the rest offf the hardware one by one untill you get an error or untill everything is back in and its up and running fine
The dos command for scan disk is scandisk
by yetolu
by dmiles
OE errors are difficult to troubleshoot,it most likely will be a hardware problem
1)reset the memory
2)check the video card by uninstalling and then make sure that you have updated drivers for your video card.
Recheck all haredware drivers to make sure they are updated.
by yetolu
by kgosnell
Hold down the CTRL Key while it boots , THis brings up the base menu, select "Step by Step", this likely will show you what is not operating. once you see or not see the problem, reboot again, and select the SafeBoot option, this is a barebones set up for Win to get around the hardware configurations, then you can go to My Computer, right click , select properties, and then device manager, look for yellow marks by each group, when you find the culprit, ask Windows to remove it if you can , and Windows will pick generic drivers for the device when it reboots, or Win will ask for the setup disk, but if it happens again, try to get Windows to use it's native drivers to operate it. Likely it's a bad setup for the device/s, and has to be done again, and it's better to use the native drivers if you can , and go get the updated drivers online afterward.
There are several commands for Dos that are platform intensive. The command SCAN , or SCANDISK should work, if not, use the command MEM to see if there is enough memory to allow it, you should look and see if you memory is full, also , there is another command that may help , SCANREG /FIX , this checks the registry, and will attempt to correct registry problems.In the future when you have problems like this , use the command SCANREG /RESTORE , if it hasn't been over 5 days, you can recover from crashes this way , as it's a native Go-back feature. Understand, I use Windows 98SE , and those commands may not operate in ME, as ME is barebones Dos , and most Dos functions are killed to the user. If you have the means , go to the MS site and look up the fix, as there is a Dos restore function they will direct you to, allowing you access to Dos. I am sorry, but ME is somewhat barebones in user function.
Hope this helps.
by yetolu
by yetolu
This discussion is closed to new replies.
Trending Windows Forum posts
Sort by Trending