Discussion Locked

Short circuit on motherboard perhaps?

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Here's a curious one. I built a system back in July with a Tyan Trinity 400 S1854 mobo, Celeron 533 CPU for a client, which has been running fine until recently. Now it doesn't power on the video display and complete the boot process unless the keyboard is unplugged first - no matter which keyboard we try.

A colleague who looked at the system in my absence is suggesting a possible short circuit on the keyboard port of the motherboard. I'm going to take a look at it next week to see if it hasany signs of shorting, but wondered if anyone here might have any further suggestion I haven't considered. We're still way under warranty for the motherboard so I have no problem with having it replaced if needed.

Any ideas?

7 replies

by nicholas paras

Are you sure it is the keyboard? Once I had a PC that once I removed the modem the pc worked fine. Needless to say the modem had a nice surge of lightening bolt through it and you could actually see the chip fried.

Check to see if it is an add-oncard which could be at fault. if it is actually the keyboard port then check to see if it has become unstuck from the motherboard. Usually a light solder should do the trick.

Nicholas.

by maggyver

Thanks for the suggestions. The system was delivered to me today, so I'll check it all out!

by mjchekal

Maggyver,
This may be a trick question, have you tried to boot the device with the keyboard attached and the mouse removed? I have seen Tyan system borads do that. I believe that it should work at that point. If yes than you have a short in the keyboard/mouse port connector or a poor ground. I believe that this is a "Feature" of the system board to protect the key bios from accidental miss configuration.

by maggyver

Hmm, very intriguing! I'll have to try that out...good to know. Sigh...I thought I was going with a reliable name with Tyan...

by chepe

Sometime, We connected the keyboard in the mouse port, and the mouse in the keyboard port.

This discussion is closed to new replies.