Discussion Locked

Short on Memory

0 helpful
11 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have a Pentium II 333MHZ with 64MB of ram. When I am running more then two programs at one time I get an error that reads.

"There is not enough free memory to run this program. Quit one or more programs and try again".

I know there is lots of memory free. I checked system resouces and there is 77% free.

Any ideas?

11 replies

by danpiers

I try to maintain at least 85% to 90% free resources at all times. (With a virus checker running, it's hard to get much above 90%.) Since you only have 77% free resources, there must be quite a few icons on your system tray. Each one is costing you resources. Look at each icon by pointing your mouse at it, and waiting about 3 seconds. Windows will tell you the name of each program. Determine whether or not you need to keep each one. Remove the software (in the Control Panel) for each one you have determined you do not need. For those programs you want to keep on your system, check to see if you can stop them from running in the background. This will free up some of your resources.
Additionally, you really need to get at least another 64MB of RAM in your system. Right now, memory prices are low...I recommend you purchase some soon. Good luck.

by lazyvanbee

another Place to check is, Start-programs-Startup, remove any programs in there by dragging to the desktop. Programs in startup run in the background and use valuable resources. Hope this helps , also take the advice to purchase more memory now,, LUCK

by saihib

CAUSE
This behavior can occur if the Win386.swp file located in the Windows folder has its file attributes set to read only. Windows uses the Win386.swp file to create virtual memory.

RESOLUTION
To resolve this issue:

Click Start, point to Find, and then click Files or Folders.

In the Named box, type win386.swp.

In the Look in box, click Drive C, and then click Find Now.

Right-click the Win386.swp file, click Properties, and then click to clear the Read-only check box.

Click Apply, and then click Close.

MORE INFORMATION
Virtual memory is designed to be dynamic. If the swap file (Win386.swp) is set to read only, Windows uses the amount of memory that is allocated. When Windows attempts to expandto compensate for programs that exceed the physical memory, system error messages are generated.

by reverendzero

I agree with the above answer. This isn't a physical memory problem, it's the swap file freaking out.

I'd also defrag and set the swapfile to a set amount instead of letting Windows do it for me.

The Reverend

by cascom

Most common cause of this problem is the presence of DOS type memory managers loaded in a Win9X session.
If you are not on a network your C:\config.sys file should be empty.
Delete any entries like "device=himem.sys" or "device=emm386.exe ........"
as these are only designed for the use of DOS based software. These entries are not required as the Win9X OS does all the memory management itself automatically.

This discussion is closed to new replies.