Discussion Locked

Slave drive VS primary hard drive / Addi

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have swapped out hard drives before. But what I want to do is buy a new computer and make my old hard drive the slave drive. Is there any documentation I can look at on the web, or is it easy to explain how to do this? Does it matter that one PC will be WIN98 and the other WIN95? Is it possible to crash the hard drive and if so what is the most recommended way to back up?

Thanks,

Rob

5 replies

by russ werner

Easily done. Set the jumper on the old hard drive from master to slave, plug it into the new computer and power up. The computer will boot from the primary drive with it's operating system, and the old drive will show up as D or some other letter if you have partitioned the new hard drive. There is no danger of crashing the old drive by doing this.

by awdfg

set your new drive as the master and your old drive as slave.for this you have to change the jumpers on the hard disks.it would be better if you have two ide cables ,then you can connect the two drives to the two ide channels available.connect the new hard disk to the primary channel and the old one to the secondary channel.in this case you need not bother about master/slave jumper settings.there is no danger of data loss in your old disk.only the drive letters will be changed.even you can boot windows 98 or windows 95 by just interchanging the connectors on the motherboard or on the hard disks, whenever you want.

This discussion is closed to new replies.