21 replies
by raffi_
There are a few other things to check before you go replacing a drive (that may or may not be the problem).
As in any troubleshooting scenario SIMPLIFY and change one thing at a time and record the results so that you know what is going on and what you have tried.
1. Have you re-installed the OS from scratch?
2. I have seen a machine hang like this after we replaced the modem and did not completely delete the old drivers and config.
3. Has the user been messing around with the BIOS?
4.Change the BIOS to make sure that it is doing a FULL memory check on boot.
5. If the RAM is in 2 x 64 then withdraw one and boot. Better? If not, replace it, withdraw the other one and check.
6. Why 2 NICs? Looking for a DHCP server, or other network resources that it cannot reach, will cause a machine to hang at GUI initialize.
In summary - I would suspect point number 6 first. Improper network setup can cause a lot of performance problems.
by janajaf
by reeree
by janajaf
by peyison
I would recommend booting without the USB hub. I had similiar problems and they were due to too many USB devices.
It would probably be good to get a faster hard drive, but a hard drive that's a little slow shouldn't be causing all these problems.
Good luck.
by janajaf
by janajaf
by paule
If after removing the devices one by one does not cure the problem. Try deleting this key in the registry: HKEY_LOCAL_MACHINE\Enum
This will remove the all hardware, but leave the software intact. Have the driver's at hand, and print out the devicemanager first. Then install one device at a time and see if Windows identifies it.PHE
by janajaf
by jmatt
BOOT LOG ANALYZER. If your computer is booting slowly, this little
freeware utility at http://www.vision4.dial.pipex.com/ may identify
the source of the delay. The Boot Log Analyzer reports the delay with
loading each DLL (Dynamic Link Library) and identifies problems some
of the DLL may be having with properly loading. The BLA won't fix your
problems, but you might be better informed so you can either ditch
the offending software or go looking for a fix.
----------------------------------------
Curing Sloooooooow Restarts
http://www.techweb.com/winmag/columns/explorer/2000/08.htm
http://216.230.195.137/newsletters/2000/2000-04-13.htm
http://216.230.195.137/newsletters/2000/2000-04-10.htm
by janajaf
by angsax
by janajaf
by vincentl
by janajaf
by deseag50
by janajaf
by pips888
click "start", "run" and type in "msconfig" a window should open.. click on the selective startup tab.. this will give you a list of all programs that windows is trying to load when you startup your mechine... uncheck the ones that you don't want windows to load when you boot your computer.. do this one at a time untill you find the one thats causing you computer to take so long to boot up..
good luck
by janajaf
by janajaf
by janajaf
This discussion is closed to new replies.
Trending Desktop posts
Sort by Trending