Discussion Locked

smtp error when sending outbound mail

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have NT4sp6a on a HP Netserver E60. IIS is installed and working, I want to set up smtp to handle outbound mail, very low usage. I have smtp installed,set up, and running in the IIS MMC. I am testing with outlook express on the iis box. I get the following error when sending:
---------------------------------
The message could not be sent because the server rejected the senders email address. The senders email address was 'chip.wiegand@simrad.com'. Subject was 'Test'. Account '157.237.65.105'. Server '157.237.65.105'. Protocol SMTP. Server response: 452 Insufficient System Storage. Port 25, Secure (SSL): No. Server Error 452. Error No. 0x800CCC78
---------------------------------------
As for insufficient server storage - this particular box has over 6gigs of available storage. As for the rejected email address - this is my email address, it works.
I check Technet and came up with no responses with this error.
I have sendmail set up and working on a FBSD box, but want the IIS smtp for a backup (though I have had no need of one yet, and don't foresee it needed, it's just for redundancy).

5 replies

by raffi_

Check the permissions on the SMTP directory and that the directories are where you expected them to be.

Regards
Raffi_

by chipw

The permissions are set to RX for Everybody. As for the location of the directories, I can only assume IIS knows where it puts it's own directories, and the smtp part should likewise. This is a default installation.

by bohicam1

hi chip, I might have this mixed up but should mail that is going out not be held on a POP server rather than SMTP server? SMTP receives mail and POP holds it till a recipient can be reached (user comes online)? Hope this helps, just reaching here.Good luck!

Mike

by chipw

SMTP is only needed to send out mail, not receive it. POP is only needed to recieve mail, not send it. I have a FreeBSD box running Sendmail and does outbound only, smtp, and has no pop installed, and it works just fine. I can't get the doggone MS smtp server to work.

This discussion is closed to new replies.