6 replies
by mckaytech
I've seen utility programs that will write your CMOS settings to a disk file for backup purposes so you can restore them when your CMOS battery dies.
That may have been useful when few CMOS settings were auto-detected but the problem has alwaysbeen that once you store the file on a drive, you still have to be able to access the drive to restore it. And when your CMOS dumps from a dead battery, drive parameters are usually one of the things lost so you may not be able to boot up to the point where you can re-load the file unless you go into the CMOS and manually set up the drives again. Further, at the very least, the date and time will be wrong if they are restored from the backup.
The whole point of CMOS and battery-backed memory was to replace physical jumpers for parameters that are required prior to boot. Getting around them by storing those parameters on a medium that requires a successful boot to access defeats the whole purpose. It's kind of a solution in search of a problem.
paul
by johnnow
by lucard
by johnnow
by bborcher
Following up on what Lucard said,
Abit Motherboards also have this feature, on my old 366 celeron , i wanted to see just howgood it would run on 200 mhz bus.. haha :P
well, it didnt really like it, so it reset my bios, restarted my computer, and here came loaded up a 'celeron 100' :P... so i had to go in the bios and also 'load back' my saved eeprom settings (That eeprom rocks :P), but anyways... yes, newer motherboards are coming up with better ways to do this stuff......
by johnnow
This discussion is closed to new replies.
Trending Desktop posts
Sort by Trending