Discussion Locked

Start up profiles

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have a machine that has a permanent Internet (DSL) connection. I would like to have a second profile that instead of using the static IP it uses I would like to attach it to my local network which has a DHCP server. Instead of manually changing the IP properties is there a way to choose a profile on start up so that depending on which profile, it will either load the static IP or in the other profile option from the DHCP server?

9 replies

by bill cassada

First of all you should be reminded of the serious security hazard posed by DSL on your network. Second, to answer your question I would need to know which OS you are using.

by mzy

I do not know much about DSL connection, but I think if you are running Windows98 SE, you can try using WindowsIPConfiguration(start menu, run, winipcfg), and select the network profile. Then, log off and log on again through the network. But, remember to install the network card and point correctly before doing that, or else windows will not detect that network ip profile. Hope this works, Maozy.

by ouropreto

Perhaps I didnt make myself clear in the question. Winipcfg will show you current parameters and will allow you to release and renew for DHCP. In the senario I am describing I want to alternate between DHCP and Static. The obvios way to to manual change the TCP properties. My question was seeing of their is a way to boot up to one of two profiles that will have either the DHCP or static configured

by robbinsr

Has your question been answered? If so please close your forum, if your question is still open please repost it with more current information. Thank you.

by james_randy

If you are still tackling this problem, perhaps you should consider calling your local super-hero.

This discussion is closed to new replies.