Discussion Locked

Still unable to upgrade to Win 2000

0 helpful
8 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I am still unable to upgrade my current Win 98 to Win 2000. I receive an error message saying
"file\$win_nt$.~bt\ntkrnlmp.exe could not be loaded. The error code is 7"

I have checked this error in the microsoft website and it said this error is due to an attempt to upgrade a Dell Poweredge 4300 computer with a MegaRAID SCSI controller

But I am not using a Dell Poweredge 4300 computer. My pc is a Pentium 2 350Mhz using Intel SE 440 BX2 motherboard. Years ago, in the same pc, when i install Win 2000 in another drive to make it dual boot, i encounter no such problem.

Anyone knows what this all about?

8 replies

by rindi1

First run a thorough chkdsk on your drives. If that doesn't help, your install media may be bad. try another CD, or try it with another CD Drive.

by bfilmfan

A couple of things to check:

Check your bus speed and see if you are overclocking. Sometimes returning the bus speed to 100 will resolve the issue.

Check for mismatched RAM.

Last, try a new installation disk.

by sgt_shultz

"Ntkrnlmp.exe Could Not Be Loaded. The Error Code Is 7" Error Message Occurs During Windows Setup
Article ID : 318729
Last Review : January 8, 2004
Revision : 1.0
This article was previously published under Q318729
SYMPTOMS
During the text-mode portion of Windows Setup, Setup may stop responding (hang) and you may receive one of the following error messages:
The file I386\Ntkrnlmp.exe could not be loaded. The error code is 7.
-or-
The file I386\L_intl.nlf could not be loaded. The error code is 7.
As a result, you cannot install Windows.
CAUSE
This behavior can occur if either one of the following conditions is true: ? There are incorrect settings in the computer's basic input/output system (BIOS) configuration.

-or-
? One or more of the random access memory (RAM) modules that is installed on the computer is faulty.

RESOLUTION
To troubleshoot and resolve this behavior, use the method that is appropriate to your situation.
Method 1: Restore the Default BIOS Settings
WARNING: This procedure may involve changing the computer's complementary metal oxide semiconductor (CMOS) settings and altering the computer's BIOS. Incorrect changes to the BIOS of your computer can result in serious problems. Change the computer's CMOS settings at your own risk.

To resolve this behavior, restore the computer's BIOS to its default settings. For information about the correct BIOS settings for the computer and about how to check and change these settings, see the computer documentation or contact the manufacturer of the computer.

by sgt_shultz

Additionally, to confirm that the computer's BIOS is current, contact the computer manufacturer to inquire about the latest BIOS update that is available for the computer.
Method 2: Remove the Faulty RAM
To resolve this behavior, remove the memory modules that are installed in the computer.

NOTE: You must leave enough RAM for the computer to start and run Windows.

For additional information about the amount of RAM that is required to run Windows, click the article number below to view the article in the Microsoft Knowledge Base:
304297 System Requirements for Microsoft Windows Operating Systems
If the error message that is described in the "Symptoms" section of this article is displayed again after you remove the memory module, remove a different memory module. This procedure may require you to restart your computer several times to identify the specific memory module that is not working correctly.

This discussion is closed to new replies.