Discussion Locked

stipe w/ pairity

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
After I select the 3 drives for stripe set with parity I get a disabled message instead of healty status after initalized

7 replies

by andygm

Do you know if you can use each drive individually? Indicating that all drives standalone are funcional. Next is BIOS recognizing all the drives as the system boots. If you do not see all drives being reconized and acknowleged by the Raid controller/Scsi controller the os will not be able to use them properly. So make sure you can go into the Raid controller setup utility usually f10 before the system boots, and examine the logical and phsyical status of each drive array. In the logical settings you should see information about how the logical array is set up eg. raid5 with hot spare. In the physical settings you should see each drive and scsi id of the devices that make up the array. All this must be working first. Check this.

by lloyd

i presume this is under NT (rather than hardware raid controller) and it's a software raid, if so you will need to commit changes etc. and reboot, more info would help.

This discussion is closed to new replies.