Discussion Locked

strange printing problem on W98 & W2K

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hi,

I have a multi-OS PC with W98 and W2K with 2 printers (Epson Color 600 and HP Laserjet 6L connectid via a AB switch) connected this Pc.
Suddenly I couldn't print anymore on both OS'
I get the message " There was an error found when printingthe document "blablabla" to LPT1: The device is not connected.
When I connect both printers to my other computer they both work fine.
I already re-installed the latest drivers.
There are no IRQ or any other problems in the device manager (all looks ok).
When I boot the W98 part in Dos mode and do a dir > lpt1, the printer is working so my parallel port seams to be OK.
I've reinstalled W98K in a VMware PC. Same result not working. only when in Dos mode.

I'm desperate. I tried everything( I think)

4 replies

by ann777

When you setup the printer within Windows, how did you answer the question about printing in DOS applications?

If you answered yes, then set the capture printer port to lpt2 (or anything else not in use)... and continue the setup. Should be fine if that is the problem.

If you answer "No," which is the default answer, then you should resetup the printer and answer "yes."

by vinnyd

Remove the switch box and connect the HP Laser directly to the computer and see if it prints.

Switch boxes cause more headaches like this when the printers using bi-direction drivers.

by borg7of9

Hi there, the first answer here has nothing to do with your problem, and the second answer of course you have to check, to eliminate the obvious.

However, testing in Dos mode made sense as this proves that the hardware itself is ok, and that you have either a problem with configeration or software.

First, you should go and check your bios settings for your LPT1 Port. Depending on the Bios you should have a number of settings such as SPP (Standard paralell port) or EPP (enhanced paralell port) alot of new printers may require that you use enhanced setting. I have seen cases where on re-boot your Bios settings go to default and thus have changed yet you do not know it. (try all settings until one works)

Another thing, is I had a similiar problem on a system, and I did all of this to no avail, then I deleted my LPT1 port (IN system>devices changed my bios settings, then let windows re-dectect the port with the new settings and everything was ok.

Another test you may wantto try in enable/disable bi directional printing in printer properties. (just change the setting to see if it makes any diff)

Well let me know if this worked!!!! and email me if you have any questions

I just thought of something else too, if above doesnt work, try changing printer properties, Spool settings, you can send job directly to the printer without spooling, and you can also try changig the format.

This discussion is closed to new replies.