Discussion Locked

strip set with parity

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have nt 4 server running. after the strip set initalizes it comes up disabled instead of healthy.. Please help..I selected 3 even partions on 3 drives. please help

7 replies

by readie

Are all partitions Formatted? With the same file system?
More information required. Are there any system errors relating to disk errors in the Event Viewer on the server? If so check the MS Knowledge base, or post a reply.

by hasan mahbub

Let me know
1. HDD Size and speed?
2. Partition Size?
3. Controller types?
Check the HDDs whether none of them are noncompatible with the others HDDs or the controllers.

See you

by william j sosville

Was this a functional stripe set? Do the hard drives contain data?

If the stripe set was created using Hardware ie. a Raid controller then I would locate a driver upgrade. Then access the config utility at bootup and install the upgrade.

If itis software Raid, (a stripe set created from within the disk manager of NT) then you would select "commit changes now" then format the drives and select drive letter etc...

This discussion is closed to new replies.