Discussion Locked

stripset parity

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have nt 4.0 after I selected 3 disks to make strip set with parity I committed changes and after it initalized the set I got message strip set disabled.. nothing I do will enable it.. what gives thanks

3 replies

by xiopus

I take it you are using Microsofts raid
(software) and not a hardware raid card.
Use event viewer and look at the entries when
you created the set. Did the set initialize
without errors? If it did not, were the
disks low level formatted on thesame scsi
card (very important!). If they weren't that
could be your problem.

This discussion is closed to new replies.