Discussion Locked

System hangs in the Cmos boot-up screen

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Just purchased a A7M266 Mobo, 1800 XP Athlon, 256 MB DDR. Joined with My from a (previous system) 40GB Maxtor. I've checked the CMOS settings all appears ok. The system freezes during boot-up. With no keyboard response. Help?

5 replies

by thechas

There are so many possabilities.

Is it at durring the POST, or at the start of loading the OS that the system hangs?

If Windows is starting to load when it hangs, there is a call in the system files that is causing the system to lock. Perhapsa DOS mode device driver for hardware that is not there.

Have you tried booting from a floppy?

If you can boot from a boot floppy, that rules out most hardware problem. Memory may still be at fault.

Check that the DDR modules are properly seated.
Double check the settings for the CPU and RAM clocks.
Are the jumpers correct on all drives?
Most hard drives require different jumpering if used as a single instead of a master w/slave.

I have had problems with a few socket A motherboards, and there are postings that recommend setting the clock multiplies manually in BIOS settings.

Make sure that you have the settings for your video card set properly in CMOS settings (IRQ, AGP apperature, shadowing)

Does this motherboard haveACPI?
Did your old MB?
If the old MB did not have ACPI, try disabling ACPI in the new MB BIOS settings until you get a clean boot.

Did you just move the hard drive over?
Or, did you remove hardware from device manager before shutting down for the last time?
You may need to place the drive back into the old system, and clean up the device drivers and system files.
Remove any device, and related software, that is not identical in the new system.

Beyond the above, if you can determine exactly where the system hangs, it would help determine what may be wrong.

Chas

by paslebcomputer

a would like more info .but if you have 1800 XP Athlon i would like to think you have win xp (i'm guessing) and if you just transfered the hardrive without deleting the hardware from the previous install xp thinks that it's the previous system boardand loads the same drivers and naturally locks up -i would format/reinstall windows

by amdkid1

It does see the Floppy drive but still freezes before it can begin to read it.
I simply moved the Hard Drive and the Video card the rest are from an older machine.

by dcosgrove

Try reseating the heatsink. You may need to apply better thermal tranfer material than the standard stuff. If you read any of my other posts, I may sound like I'm harping or something, but anytime I get careless with AMD processors, they come backoverheating. SOP for me now is to remove the black pad and apply arctic silver compound instead.

by amdkid1

This Problem is has been solved...
Must first use a non-XP processor (Duron) in this case. Flash the BIOS to 1006.ver then turn off machine install the XP (1800) then boot and set CMOS to desired settings. Done

This discussion is closed to new replies.