Discussion Locked

System Info: changing IRQ's

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
When I look in the SYSTEM INFO. on a Win2k Pro machine I see IRQ11 being used by 3 devices under Conflicts/Sharing. HOw can I manually change these to use differenet IRQ's? Does it have to be done in the BIOS or Windows?

9 replies

by ciscofred

Turn off PnP in your bios and boot into windows 2000 and change your IRQ settings. Good Luck!

by cgi¤001

First: write down the conflicts.
Second: some devices are preferable not changed, but soundcards, FDD controllers and alike can be easely changed, if you avail the manuals of those. IRQ's have to be changed on the device b4 you change in Windows. PC turned off! change the IRQ on ONE of the two devices conflicting, by changing the pin (read the manual!!!), reboot, change the IRQ setting in windows.
Repeat the same step, for each pair of conflicts, one by one. Its easier to undo one thing, if things go wrong. Be aware of statical electricity! If you are not enough technical, ask a technician!
Hope this clears the issue. BTW, always back up your IRQ setting log file. There again, you can turn back the clock if needed.

by cgi¤001

First: write down the conflicts.
Second: some devices are preferable not changed, but soundcards, FDD controllers and alike can be easely changed, if you avail the manuals of those. IRQ's have to be changed on the device b4 you change in Windows. PC turned off! change the IRQ on ONE of the two devices conflicting, by changing the pin (read the manual!!!), reboot, change the IRQ setting in windows.
Repeat the same step, for each pair of conflicts, one by one. Its easier to undo one thing, if things go wrong. Be aware of statical electricity! If you are not enough technical, ask a technician!
Hope this clears the issue. BTW, always back up your IRQ setting log file. There again, you can turn back the clock if needed.

This discussion is closed to new replies.