Discussion Locked

Time Server

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Greetings!

All of our server's time are not synchronized, we are changing time using NET TIME on each server. How can we create a time server???

Thanks,

Red_Silva

7 replies

by tonyp_fno

Don't know about the previous software meantioned but It would be pretty straight forward to write a batch file and have it run under scheduler. If the script runs once a day the servers should all be pretty close on time unless you need it for precise time loging.

by skkzarg_death

The above post is correct.. use W32time.exe
the key is making sure your use the right syntax.

Read the following:

http://support.microsoft.com/support/kb/articles/Q216/7/34.ASP

I use the 2 servers referenced in the article since they are US Naval Observatory time servers.
Depending on how one reads your request, you may be asking how to make a server BE a time server. To do that, just point the PDC to its own IP addy using w32time.exe, then run the cmd with the /set switch. Finally, point your other servers, bdc's, etc to the PDC as the time server with the same w32time command. Remember to make each machine update its time after changing its time server.

Its easiest if you point your PDC to an exterior time server, them make your other servers home to the pdc for time. Makes things alot easier.

Qapla!
Skkz

This discussion is closed to new replies.