I've found that on more than one occasion with PentiumM systems,
even when the chipset etc. is technically supposed to be fully 48-bit bit compliant, the nuts doing the BIOS forcibly limit it to 28-bit and some even limit the drive size below the max 28-bit LBA limit
ie.
- a 2005 Compaq NC6220 Pentium-M, Max. "Supported" HDD is limited to 80GB, though it will function with a 120GB, certain HDD tools don't even see the drive, and others can see the drive but can't perform any testing, etc.
and yet a 2002 Compaq Presario 6330CA P4 mini tower is fully 48-bit compliant and will use the the largest IDE drives available
(I have 1x 320GB & 2x 500GB installed in it)
one thing with recovery media is a lot of them just dump a block of sectors onto the HDD, providing the restore sees there is enough sectors to hold the factory installation
ie. if the system normally ships with a 40, 60, or 80GB HDD the restore media will restore to a 40, 60 or 80GB without questions
but if you were to put say a 10GB HDD in and try the restore it might balk at it
or start the restore and fail at some point near the 10GB mark or right at the end of the space.
with a 160GB drive installed the factory restore process sees enough sectors, dumps the factory installation onto the drive, but if the BIOS is limited to smaller drives by 28-bit addressing or forcibly programmed to limit the drive size, or both,
that could possibly explain the "no boot" issue