Question Locked

Toshiba Qosmio F15 won't boot, power only, no HD activity

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Here's the pream.....the pc started locking/freezing up periodically for no apparent reason. I ck'd TM and all it showed was alot of system idle usage. Then I added a wireless mouse and keyboard via USB. It started "acting stupid",not recog. commands,etc. The next day I went to boot up and the power lights on but the drive light only blinked once. The CD/DVD spins for a short then stops. The fan runs but is noisy. Nothing on the screen. I have taken it apart and cleaned, reseated mem card, ck'd connections, and tried to clear CMOS. I am @ a loss. Please help, cannot afford to take to shop but need data.

9 replies

by seanferd

and plug it in without the battery. see if that works.

Otherwise, it sounds like it is underpowered (if you have a lot drawing power from USB ports) or overheating.

by norazmataz

I appreciate ur response but sadly I have tried that with the battery to no avail. As for overheating, wouldn't it have started after sitting awhile?

by rob miners

Or you can use either of these connectors.
USB 2.0 to IDE / SATA Adapter Cable 80cm (Supports 2.5" & 3.5" IDE)
Notebook IDE Hard Drive Adaptor will allow you to connect as a Slave to your System.

The Data connectors can be either IDE 40 pin or Sata. IDE is a wide/flat ribbon cable with either 40 or 80 wires where Sata is a thin plastic cable with thin connectors.

You will have to determine the Hard Drives physical size and data connectors before purchasing a USB Enclosure. If it is from a Notebook then it will be 2.5"

Example:

http://www.skycomp.com.au/product.aspx?id=89551

by norazmataz

Thanks for the reply. That is a great idea. At least I will have access to the data which is the most troubling. I am gonna leave this post open though cause I am still quite puzzled as to the reason for the laptop to die like it did and maybe somebody out there has experienced it before or knows someone who has.....???
thanks again

by fflores818

I have an enpower laptop. It was working fine until I decided to take it with my to a trip.
I turned it off, unpluged it, and when I try to power it on, it would not boot up. There is power and I can hear the fun running for a short while but then it stops. The screen, well, it is black. I don't even see the bios come up.
Does anyone know what is wrong?
Thank you

by zorod

I'm figuring it is a hardware issue... so I have it in the shop for a diagnostic first. I get one (sometimes 2) short beeps from the motherboard and then nothing. Computer is 'on' if you could call it that altough the harddrive never gets a chance to boot.

by seanferd

That will give you anywhere from a general idea to very specific information.

Installed any new hardware recently, like RAM or graphics?

As it is in the shop, the point is fairly moot, unless you are just trying to satisfy your curiosity before the shop fellows do. :)

This discussion is closed to new replies.