Discussion Locked

Trying to FDISK

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

While trying to FDISK a hard drive a message came up that I was unfamiliar with:
"Could not change partitions, because the disk could not be locked." The machine is running Windows ME, has only 1 primary partition with no extended partitions. Is there anything I should reconfigure before the FDISK procedure? Any help would be greatly appreciated.

7 replies

by bohicam1

Have you tried "lock /?" from the dos prompt?
I have been in there once before for the same reason..check to see what switches you need to use to lock this drive. If all else fails, run HD_KILL or CLEARHDD to totally wipe anything from the drive and start again.
Good luck!

Mike

by mike (from canada)

before I use FDISK on my hard drive, I format it with the bios. you can try that then EVERYTHING on your disk will be erased. you must use FDISK before FORMAT.

by rdschaefer

Why are you trying to run FDisk while ME is running? If you are NOT trying to wipe the drive, why are you running FDisk?

If you DO want to wipe the disk, you have to boot from a floppy. NT, ME, and 2K all protect the active partition while running.

Ralph

This discussion is closed to new replies.