Discussion Locked

Turn off Print Acknow on NT4 Print Serv

0 helpful
14 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
How do I turn off that annoying print acknowledgment on NT 4 Print Servers?

14 replies

by mphoffar

You're probobly better off just turning off the messanger service on the local station so you don't get that.

Mark

by duwaned

Disabling the messenger service is not ideal, as it will stop all messages, even useful ones!

The is a registry change that can be made on the machine that holds the print spool for the relevant printer. Create a new REG_DWORD named "NetPopup" with a value of "0" (zero) in the following registry key: HKEY_LOCAL_MACHINE\SYSTEM\CurrentControlSet\Control\Print\Providers. To re-enable this notification, set the value to "1". The machine will need to be restarted before the changes will take effect.

I hope this helps.
Regards.
Duwane.

by rcc

You should turn off the printer notification on the Print server. Just go to the printers in control panel, menu, File, Print Server Properties, Advanced TAB, and uncheck the Notify when remote documents are printed.
NOTE: it will ask you to reboot the server. Usually restarting the Spooler service does the job
Regards,
Radu

by flan

there is no advanced tab on the server that shares the print devices

by cavedweller

You must be either not following the answer carefully or not running NT-4 on the print server. I traced the solution in #3 and found the advanced tab right where he said it should be.

by flan

your right, i was looking for the advanced tab for each device. as soon as rcc replys again, i'll give him the credit

by rcc

Would you be kind to tell us what TABS to you have when you open the Printers applet in the Control Panel and go to the menu, File, Server Properties? Is it NT4 with SP5 or greater?

by flan

i just opened the individual printer setting, not the global ones. i also use nt server 4.0 sp6a
thanks

by rcc

I see you got to the end of it.
I suppose it will be fair to share credits with cavedweller.
Thank you and I'm glad to be of assistance.
Regards,
Radu

This discussion is closed to new replies.