Discussion Locked
0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
How do I configure the routing table for a single PC with two Ethernet cards so that I can force the communication from one card through a HUB to a wrap connection back to the other PC card? This is for test purposes to check the communication paththrough the HUB. The PC presently wants to communicate to the other card across the backplane.
3 replies
by poo_music
I assume that you are using Window's NT OS, use a Routing table just easy, perform this command:
route add source_ip mask subnet_mask Destination_IP
you can double check via the command - route print
Do have a try
Have a nice day,
Cheers!
by shanghai sam
I am using windows NT but so for have not been able to set up the routing table so that the communications will be forced through the external cable. I want to thank you for the comment though.
by kmagress
I doubt you'll be able to solve this through the routing table, since it's tough to get better than a connected route.
Instead, try using "ping -k" or "ping -j" to force source routing of your ping requests. Your router may block source-routed pings, so if it fails, you may need to tweak its config.
This discussion is closed to new replies.
Trending Windows Forum posts
Sort by Trending
2 helpful
25 replies
Discussion
Do you think that business directories are relevant to Local SEO And Lead Generation today
0 helpful
16 replies
0 helpful
6 replies
0 helpful
12 replies
1 helpful
9 replies