Discussion Locked

UDLs and Ports

0 helpful

3 replies

by mike.dale Sep 26, 2001 last reply Oct 25, 2001

Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

What port does an Microsoft Universal Data Link (UDL) use?

3 replies

by jay eckles Sep 27, 2001

I'm pretty sure it depends on the settings of the datasource. If you're using DB2, then most likely the port defaults to 446, just from looking at msdn articles. If you're using OLE DB or ODBC, then the settings are specific to the actual data source; look in your db documentation.

Good luck.

Jay Eckles
www.jayeckles.com