5 replies
by cfrank01 Accepted solution
by hal 9000 Accepted solution
You'll need a Floppy Drive and the Floppy Disc that came with the M'Board with the SATA or RAID Drivers on it and then you'll need to copy the correct SATA Drivers to the Root of a Floppy.
When this is done restart the Vista Install and on the first Blue screen press the [b]F6[/b] telling Vista that you need to add drivers and when Vista comes to the end of its initial setup it will ask for the Floppy with the drivers on it. Place this floppy into the Drive and press enter and the SATA Drivers will be found at the Root of the Floppy Disc and installed. Then Vista should load. Previously I've used XP Drivers with the 32 Bit Version of Vista and they have worked though Vista drivers would most likely be better if they are available. I'm not sure about the 64 Bit Version of Vista as I don't have a RTM Copy only a Beta and that is significantly different as not to be of any use.
Col
by cfrank01 Accepted solution
by hal 9000 Accepted solution
And is available here
Plese Note that this is a [b]Beta Driver[/b] and may have some bugs in it as the finial Vista Version is not yet available.
Actually if you look at all the Vista Drivers listed on this Page every one is called a [b]Beta Version Driver[/b] because as yet the finial release for Vista is not available so there may be bugs in every driver.
Col
by cfrank01 Accepted solution
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending