Discussion Locked

Unable to boot my PC

0 helpful
13 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I can't boot my PC, there is this message saying 'please check the signal cable.'

I have checked the connection to the monitor and have also tried open up the CPU to make sure connection is ok, I have also checked the RAM to see if it's properly in place. I have done everything I could think of but still can't solve the problem. Please help. Thank you.

13 replies

by danpiers

Assuming that you made sure that the connections from the computer to the monitor are still secure, the next thing to check is the video card inside the computer. With power off, I would remove it from the system and re-install it. Then try to boot the system again.
If this does not work, I would be thinking about what happened between the time the system last worked properly and the first time it did not work. Did you move the computer or monitor? If so, the video cable may have been damaged. Did you have a power failure? If so, it is possible that some electronics inside you computer was damaged. Did you have to plug the monitor into the computer because it became disconnected? If so, I would remove the video plug from the computer and carefully check the pins. Were you working inside the computer? If so, you may have disconnected a cable, or worse, reconnected a cble incorrectly. Often, the problem you describe is something easily repaired.
The only good thing isthat your monitor is definitely working!

by lo

Hi - I had same error a few weeks back. Died after I did some Partition Magic V6.0 to resize partitions. Changed, booted several times then, same error.

I have wo extra monitors, a matching MB / CPU + a PIII 600. Switching/swapping/etc. I never did get it to work reliably. I gave up and bought another MB/CPU and case. That worked fine with old cards and memory. Still have to try to see what was wrong with the others, ... as soon as I get time.

by hamiltonreps9aa

Signal cable problem is the signal to the monitor.. So check the pins on the monitor cable..If it is not that then it must be a defective video card.

by vopro

I'm going to take a crack at this one and say that it could be the refresh rate on your monitor. I have run into the problem of the number of colors getting messed up in the display settings and then when the computer is rebooted the monitor cannothandle the settings and sends out a "check signal cable" message across a black screen. The way that I fixed this before is to boot into safe mode and go into the display settings in control panel and lower the color settings and refresh rate on the computer. Reboot and it should come back to you. I would love to know if this fixed your problem. Good luck to you.

by jerry_m

If you feel ok that your monitor is good and you have a video card (not vid on the board)
then shut down and re-seat your vid card.
Re-boot, if you still have the prob then move your vid card to another slot and try again.

by whoopi cushion

Just a thought: When you turn on your pc, do you hear the cooling fan in the power supply? Do you hear any beeps during the bootup? The "check signal cable" is the message the monitor can display to tell you it's getting nothing from the computer, and commonly that is because the pc has a fundamental problem. If you don't hear the cooling fan in the power supply, it's probable that your power supply has failed. Beeps during bootup can indicate a problem with the motherboard. Good luck with this.

This discussion is closed to new replies.