Discussion Locked

Unable to boot OS

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
On PC with win98 SE after "POST" it does not go any further, with message "insert system disk", it hangs. When bootable disk it goes upto Pscan then hangs. Tried to reinstall, but does not find any partion, FAT missing message appears; therefore unable to see hard drive. Also unable to FDISK. Windows is there, tried to add HDD as sec/slave to read from Master from explorer but unable to see the drive. Need help to recover the hard disk.

9 replies

by thechas

Double check the jumpers on HD, and BIOS settings for HD detection.

If you cannot fdisk, the drive is either not recognized properly, or has a serious problem.

If the FAT is indead missing, your best bet is a drive recovery utility.
Check outwww.pcwiz.com

You can try putting the mis-behaving drive in another system as a slave, or on the 2nd IDE channel. But, if the FAT and partition table are not accessable, you may be out of luck.

by dmiles

If you have not made any chnges to system,you may have a hard drive going bad
Insert the floppy in A:\drive and boot computer,choose the option to run setup without cd-rom support,
after process is complete reboot computer
Run scan disk to see ifyou have any bad sectors
If you think that the hard drive is going bad,consider backing up hard drive or checking the past articles on 200 ways to revive hard drive
Check the cables to make sure they are inserted to drive properly,could be a bad ribbon cable

by yteebison

You won't be able to connect a slave to the master or at least it won't be able to read the slave if it is not recognising the master.
Enter the BIOS by pressing normally delete or F2 key.
Check to make sure that the first bootable option is set to C:\ or harddisk.
Even if it is is set to C:\ reset it to A:\ or CD ROM then reset it to C:\ and press F10 to save changes. The CMOS can sometimes get confused but this may sort it.
Hope this helps

by otl

Possible the MB is going bad, saw problem with secondary IDE which was intermittent, would boot sometimes but not consistantly. Have you tried another bootable hard drive?

Looking back at symptoms, sounds like the computer is not communicating with the hard drive, indicates HD is bad or going bad. Have you tried the HD in another system? If it works then is a HD problem.

To get info off HD TECHREPUBLIC has a white paper titled "200 ways to revive a hard drive", freezing usually works.

Good Luck !

This discussion is closed to new replies.