Discussion Locked

Unable to clock to 1.4 mhz with ak73proa

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I've just assembled an ak73 pro (a) running a 1.4 mhz amd cpu. When I booted up, the speed was showing 1052 mhz x 10.5. This ran ok. I changed the jumper fsb from 100 to 133 and the pc then boots up showing 1.4 mhz but then freezes shortly after boot up has finished. I changed the dip switch from default to 10.5 X 133, but this didn't help.

9 replies

by csmith

This is not a CPU problem.
This is usually a memory problem.
Check CAS is set to 3 (Not 2) in the BIOS.
Check the SIMMs to make sure a 100 did not get mixed in.
Swap the SIMMs in their slots to check for a bad chip on one of the SIMMs.
Go back to the original 100 MHz FSB and run a memory test program.
One of these tests should show the problem.
Regards, Chris

by csmith

:
I am assuming that you mounted the heat sink properly.
A poor contact between the CPU and the Heatsink can also cause this. (Not Common, but it happens.)

Regards, Chris

by csmith

I assumed you had the proper CPU. Its worth a check, things happen.
The suggestion in Ans. #2 to try some 150 MHz memory is also a good troubleshooting technique.
Regards, Chris

by rodldavis

Also the 1.4 chip comes in 100 and 133 bus specs be sure and check the chip at AMD
as well as the memory should be a quality CAS2 133 or better or but a stick of 150+ memory it is cheap now

by rodldavis

Forgot to have you get the latest Bios for your board this timing was not available until lately

This discussion is closed to new replies.